Dale Winebrenner Senior Principal Physicist Research Professor, Astrobiology Program and Earth & Space Sciences dpw@apl.washington.edu Phone 206-543-1393 |
Biosketch
Dr. Winebrenners' interests are in the physics of light and radio waves, and in the exploration of icy environments on Earth and elsewhere based on that physics.
For sea ice, he has developed a physically based method to observe the springtime melting and fall freeze-up transitions on Arctic sea ice using synthetic aperture radar, and has shown that polarimetric microwave backscattering from thin sea ice depends on ice thickness and thus may be useful for remote thickness estimation. Recently he has investigated the optical fluorescence from chlorophyll in sea ice, with the aim of estimating phototrophic biomass near the ice-water interface.
Microwave emissions are used to map (decadal-scale) mean surface temperature and accumulation rate fields, for ice sheet on both Greenland and Antarctica. Most recently, Dale Winebrenner has begun to investigate meter-wavelength radar sounding of ice sheets. The first result of this work is a new means of estimating electromagnetic absorption within the ice sheet.
Education
B.S. Physics, Purdue University, 1979
M.S. Electrical Engineering, University of California, San Diego, 1980
Ph.D. Electrical Engineering, University of Washington, 1985
Videos
Ice Diver: A Thermal Ice Penetrator Ice Diver is a thermal melt probe system for extensive, low-cost sensor deployment to the bed of the Greenland Ice Sheet, where it will measure water pressure in subglacial hydrological networks. |
23 May 2013
|
Publications |
2000-present and while at APL-UW |
Impacts of hydrostatic pressure on distributed temperature-sensing optical fibers for extreme ocean and ice environments Tyler, S.W., M.E. Silvia, M.V. Jakuba, B.M. Durante, and D.P. Winebrenner, "Impacts of hydrostatic pressure on distributed temperature-sensing optical fibers for extreme ocean and ice environments," Photonics, 11, doi:10.3390/photonics11070630, 2024. |
More Info |
2 Jul 2024 |
|||||||
Optical fiber is increasingly used for both communication and distributed sensing of temperature and strain in environmental studies. In this work, we demonstrate the viability of unreinforced fiber tethers (bare fiber) for Raman-based distributed temperature sensing in deep ocean and deep ice environments. High-pressure testing of single-mode and multimode optical fiber showed little to no changes in light attenuation over pressures from atmospheric to 600 bars. Most importantly, the differential attenuation between Stokes and anti-Stokes frequencies, critical for the evaluation of distributed temperature sensing, was shown to be insignificantly affected by fluid pressures over the range of pressures tested for single-mode fiber, and only very slightly affected in multimode fiber. For multimode fiber deployments to ocean depths as great as 6000 m, the effect of pressure-dependent differential attenuation was shown to impact the estimated temperatures by only 0.15°K. These new results indicate that bare fiber tethers, in addition to use for communication, can be used for distributed temperature or strain in fibers subjected to large depth (pressure) in varying environments such as deep oceans, glaciers and potentially the icy moons of Saturn and Jupiter. |
Microbial transport by a descending ice melting probe: Implications for subglacial and ocean world exploration Schuler, C.G., D.P. Winebrenner, W.T. Elam, J. Burnett, B.W. Boles, and J.A. Mikucki, "Microbial transport by a descending ice melting probe: Implications for subglacial and ocean world exploration," Astrobiology, EOR, doi:10.1089/ast.2021.0106, 2023. |
More Info |
6 Jun 2023 |
|||||||
Ocean Worlds beneath thick ice covers in our solar system, as well as subglacial lakes on Earth, may harbor biological systems. In both cases, thick ice covers (>100 s of meters) present significant barriers to access. Melt probes are emerging as tools for reaching and sampling these realms due to their small logistical footprint, ability to transport payloads, and ease of cleaning in the field. On Earth, glaciers are immured with various abundances of microorganisms and debris. The potential for bioloads to accumulate around and be dragged by a probe during descent has not previously been investigated. Due to the pristine nature of these environments, minimizing and understanding the risk of forward contamination and considering the potential of melt probes to act as instrument-induced special regions are essential. In this study, we examined the effect that two engineering descent strategies for melt probes have on the dragging of bioloads. We also tested the ability of a field cleaning protocol to rid a common contaminant, Bacillus. These tests were conducted in a synthetic ice block immured with bioloads using the Ice Diver melt probe. Our data suggest minimal dragging of bioloads by melt probes, but conclude that modifications for further minimization and use in special regions should be made. |
Experimental validation of cryobot thermal models for the exploration of ocean worlds Pereira, P.D., and 19 others including D.P. Winebrenner and W.T. Elam, "Experimental validation of cryobot thermal models for the exploration of ocean worlds," Planet. Sci. J., 4, doi:10.3847/PSJ/acc2b7, 2023. |
More Info |
5 May 2023 |
|||||||
Accessing the potentially habitable subsurface waters of Ocean Worlds requires a robotic ice probe (or "cryobot") to traverse tens of kilometers of ice with temperatures ranging from ~100 to 273 K. Designing and planning such a mission requires understanding ice probe behavior as a function of the local environment and design parameters. We present experimental results of two laboratory melt probes in cryogenic (79 K) and warm (253 K) ice. The melt probe tested in warm ice had multiple adjustable heaters, enabling optimization of the system's efficiency. The melt probes tested in cryogenic ice operated in vacuum and had internal tether spools, allowing for experimental confirmation of hole closure and the creation of a pressurized pocket with liquid water around the probe. These melt probes were tested at power levels ranging from 120 to 1135 W, achieving descent speeds between 5.3 and 59 cm hr-1. By analyzing the relationship between power and speed using analytical and high-fidelity numerical models, we demonstrate progress in understanding melt probe performance. We distinguish between the previously confounding terms of probe operational inefficiency and analytical model inaccuracy, allowing us to understand the range of applicability of the analytical models and demonstrate the importance of controlling heat distribution in cryobot design. The validated models show that while numerical models may be required to describe the behavior of short probes descending in limited-size laboratory test beds, the performance of efficient cryobots designed for operation on Ocean Worlds can be predicted by analytical models within 5% error. |
In The News
UW part of $25M NSF-funded effort to retrieve Earth’s oldest ice core UW News The new Center for Oldest Ice Exploration, or COLDEX, will be created under a five-year, $25 million National Science Foundation grant. Roughly $5 million of that grant will go to the UW. One aspect of COLDEX will involve new development of a probe, the Ice Diver, that melts through layers of ice and provides information about the age of the ice and other data without having to lift a core back up to the surface. |
14 Sep 2021
|
Researchers test ice probe on Mount Baker Skagit Valley Herald, Kimberly Cauvel APL-UW researchers received help from a local snowmobile club to reach Mount Baker's Easton Glacier at an elevation of about 8000 feet to conduct tests of the 'ice diver' probe an electrically-heated instrument that pierces glacial ice to measure the physical and biological environments below. |
15 Jun 2019
|
The ice of a distant moon Science News, Meghan Rosen Scientists around the world are trying to figure out how to pierce the thick, icy shell of Europa to search for life below. Dale Winebrenner is quoted. |
2 May 2014
|
Inventions
Methods and systems for assessing a burn injury The present invention provides methods, software, and systems for assessing a burn injury. Patent Number: 9,295,402 Hassan Arbab, Antao Chen, Dale Winebrenner, Trevor Dickey, Pierre Mourad, Matthew Klein |
Patent
|
29 Mar 2016
|
Terahertz spectroscopy of rough surface targets Patent Number: 9,261,456 Hassan Arbab, Antao Chen, Eric Thorsos, Dale Winebrenner |
More Info |
Patent
|
16 Feb 2016
|
||||||||
A method and system for analyzing noisy terahertz spectroscopy data transforms the measured time-dependent data into frequency space, for example, using a discrete Fourier transform, and then transforms the frequency spectrum into wavelet frequency space. The twice-transformed data is analyzed to identify spectroscopic features of the signal, for example, to identify a resonance frequency. The method may be used, for example, in a stand-off detector to identify particular chemicals in a target. |